|
 |
| |
|
|
| |
 |
| |
Amcon epoxy Underwater Repair Putty - is a fast setting, fiberglass - reinforced polymer compound that enables permanent repairs to many surface including fiberglass, concrete, glass metals, wood and many plastics. It is specially formulated to adhere to surface exposed to damp, wet or underwater (salt or fresh) conditions.
It is Non-rusting and it contains No Solvent or VOC's It's non-flammable and releases no noxious fumes. It wont shrink or pull away. |
|
|
| |
Surface Preparation
Surface must be clean and free of oils, grease and loose contamination.
For Best Results : Use damp fingers for easier mixing and application.
Application
- Cut or twist off required amount.
- Mix by kneading with fingers to uniform color. If mixing is difficult, warm the putty to room temperature or slightly above.
- Apply to surface to be repaired (within two minutes of mixing) Force into cracks or holes and strike off excess material, preferably with tool wet with clean water.
Pot Life
It has a work life of approximately 15 min.
Curing Schedule
After 20-30 minutes it will harden and form a tenacious bond. Final cure occurs in 60 minutes.
Machinability
After curing, it can be machined, drilled, tapped, sawed,ground, filed or painted.
|
|
| |
|
|
| |
| Physical Properties |
|
| Shelf Life @ 75°F, mths |
24 |
| Shore D Hardness |
70 |
| Lap Sheer Tensile Strength,On Steel |
900 psi |
| Lap Sheer Tensile Strength,On Fiberglass |
500 psi |
| Compressive Strength |
12,000 psi |
| Density (gm / cm3, lb / gal) |
1.9, 15.8 |
| Shrinkage (%) |
<1 |
| Non - Volatile Content (%) |
100 |
| Electrical Resistance (megaohms) |
30,000 |
| Dielectric Strength (volt / mil) |
300 |
| Upper Temperature Limit Continuous (°F) |
250 |
| Upper Temperature Limit Intermittent (°F) |
300 |
| Chemical Resistance |
Refer to product Data Sheet |
|
|
| |
|
|
| |
|
|
| |
|
|
|
